Your water heater is one of the most used and costly appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and energy costs.

Regular flushing of one’s water heater is considered the single most important step you get to prolong its service life and to save energy. A duration of time, sediments mount up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most areas of the country, the average water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is a must in today’s markets. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month or so.

To drain your water heater, first you should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to drinking water heater. Next, close the water supply valve located on the water inlet line going into your water heater. Equipped to connect a hose to the drain valve located in the bottoom of the space heater. Open the drain and allow it to function until all on the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until the flows out quickly. This will allow air to vent off of the heater and the hot water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas which have hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and products to be fitting.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2